Linear Speaker H481 6 User Manual

H481-6 INSTALLATION  
The new-construction brackets are designed to enable installers to  
identify and preserve the installation location of in-ceiling speakers  
before the drywall is hung.  
®
The brackets feature interlocking flanges (wings) which connect to the  
bracket frame and enable the speakers to be mounted in almost any  
position.  
STEP 1 - Place the bracket  
face down on a hard surface,  
and place the wings in their  
desired positions.  
DAMPING THE WALL CAVITY  
STEP 2 - Once in place, use  
the palm of your hand to  
apply equal pressure to  
the back of the Wing/Bracket  
joint until the wing snaps into  
place.  
The performance of your speakers will be enhanced by using flame-  
resistant fiberglass insulation to dampen the wall or ceiling cavity  
around and behind the speakers.  
Doing so will reduce the transmission of sound into adjacent rooms or  
floors while enhancing the speaker's bass response by deadening the  
sound waves emanating from the rear of the woofers.  
MOUNTING THE NEW-CONSTRUCTION BRACKETS  
FIGURE 1  
1. Decide on the installation location for your speakers. NOTE: Be  
sure the locations you choose are clear of high-voltage wiring,  
piping, or other obstructions.  
2. Attach the bracket flanges to the bracket frame as shown in Figure 1.  
NOTE: Make sure the dimpled side of the flange faces OUT and  
interlocks with the frame from the rear.  
Attach using flat-head  
screws or heavy-duty  
staples  
3. Once the flanges have been attached to the frame, secure the  
bracket assembly to the wall studs or ceiling joists with flat-head  
screws or heavy-duty staples. See Figure 2.  
4. You may choose to have the drywall contractors CAREFULLY and  
ACCURATELY cut the speaker holes for you using a routing tool or  
similar device. Discuss this with them prior to doing the work to  
ensure good results. NOTE: The bracket frames are constructed  
of heavy-duty ABS plastic but are not unbreakable – ALWAYS  
USE CAUTION.  
FIGURE 2  
5. After the drywall is up and the holes are cut, you may choose to  
give the speaker frame and speaker grille to the painter for painting  
(see the H480-2 speaker manual for painting instructions).  
Warranty  
Linear LLC warrants this product to be free from defects in material and workmanship for two years (2 years). The time period will be measured using the date code labeled on the  
product. Linear LLC is not responsible for damage to the product resulting from the buyer's improper handling, stocking or warehousing of the product. Any implied warranty aris-  
ing from the sale of the product including implied warranties of merchantability and fitness for purpose are limited. Linear LLC shall not be responsible for any losses, damages or  
expenses, whether direct, consequential, or incidental arising from the use or the inability to use the product. Some states and countries do not allow limitations on how long an  
implied warranty lasts or the exclusion or limitation or incidental or consequential damages, so the above exclusions may not apply. The Linear LLC warranty gives specific legal  
rights in addition to other rights, which may exist and vary from state to state and country to country.  
The warranty is limited to repair or replacement of products returned, freight prepaid, to Linear LLC, there is NO PROVISION FOR LABOR COST OR OTHER REIMBURSEMENTS OF ANY  
KIND.  
1. Failures due to product abuse, such as negligence, improper use, and electrical surge including damage from lightening, water damage or other damage due to natural  
disasters are not covered by the warranty. The most common form of product abuse is surge damage caused by lightening.  
2. The warranty shall also be voided by any tampering with the date code, labels or other markings on the product.  
3. Products that are damaged in transit to Linear LLC due to improper packaging or by the carrier (shipping company) will not be covered under the warranty. If the product was  
damaged or lost by the carrier, it is the sender's responsibility to create a claim against the carrier.  
4. The user is responsible for all labor costs associated with removing, reinstalling and returning the product to Linear LLC.  
Linear LLC, at its option, will repair or replace the defective product. Replacements will be made from B-Stock, if an exact replacement is not available, Linear LLC, at it's option,  
will select the nearest equivalent product. The user is responsible for freight charges to Linear LLC. Linear LLC will return warranted repaired or replacements by UPS Ground or an  
equivalent service. A customer may pay the additional costs for second-day or next-day service.  
All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Linear Technical Services at 1-800-999-5225 for an RPA# and other  
important details.  
Copyright © 2004 Linear LLC  
P/N 9900537 X2  
 

Krell Industries Stereo System SBP 32X User Manual
Lenovo Computer Monitor L2062 User Manual
LevelOne Network Router WBR 3402TX User Manual
Lexmark Network Card 33S0258 User Manual
LG Electronics Washer WM1437BFD User Manual
Liebert Power Supply PSITM User Manual
Magnavox Clock Radio MCR220BK User Manual
Maxtor Computer Drive 7B250S0 User Manual
McCulloch Pressure Washer 7096 280105 User Manual
Memorex Clock Radio VX517 User Manual