Linear Smoke Alarm DXT 72 User Manual

PRODUCT DESCRIPTION  
REMOVE MOUNTING PLATE  
The DXT-72 is a photoelectric smoke alarm with a built-in  
transmitter designed for use with Linear’s DX Format receivers.  
When smoke is detected, the alarm sounds a loud local  
alarm. Twenty seconds after the local alarm sounds, the built-  
in transmitter sends a digitally coded wireless signal to its  
companion receiver. The wireless signal will be repeated every  
20 seconds as long as smoke is still present.  
DXT-72  
TWIST MOUNTING  
PLATE TO  
UNLOCK  
BY  
REMOVE  
MOUNTING  
PLATE  
WIRELESS  
PHOTOELECTRIC  
SMOKE  
The digital DX code format features over a million possible  
codes.The DX transmitters are precoded at the factory to unique  
codes, so no field coding is required.The DXT-72 can send three  
different codes: alarm, test and low battery.  
ALARM  
For versatility, any transmitter can be programmed into any  
receiver channel. Receivers must be programmed to the  
transmitter’s code before system testing and operation. Refer to  
the receiver’s instructions for details on programming.  
Installation  
Instructions  
The unit is powered by two 9-volt alkaline or lithium batteries.  
These batteries are supplied with the transmitter and can power  
the unit for up to two years. If the battery voltage drops below  
a preset level the alarm will sound low battery beeps and a  
low battery signal will be sent to the receiver every hour (some  
receivers can report low battery, others cannot).  
(760) 438-7000  
NOTE: After replacing batteries, press transmitter test  
button to reset “low battery circuit”.  
USA & Canada (800) 421-1587 & (800) 392-0123  
Toll Free FAX (800) 468-1340  
DXT-72 FEATURES  
INSTALL BATTERIES  
CHOOSE ALARM LOCATION  
PRESS TRANSMITTER TEST BUTTON  
AFTER INSTALLING BATTERIES  
TO PRE-SET LOW BATTERY CIRCUIT  
TRANSMIT LED  
TRANSMITTER  
TEST BUTTON  
TRANSMITTER  
BOARD  
CONNECT AND INSTALL  
TWO 9-VOLT DURACELL  
ALKALINE MN1604 OR  
ULTRALIFE LITHIUM U9VL  
BATTERIES  
BATTERY  
HOLDING  
CUPS  
INSTALL MOUNTING PLATE  
PROGRAM RECEIVER  
MOUNT ALARM ON PLATE  
MATCH UP  
ALIGNMENT  
TABS  
REFER TO RECEIVER'S INSTRUCTIONS  
TO PREPARE RECEIVER TO ACCEPT THE  
TRANSMITTER'S CODE  
SCREW  
ANCHORS  
FOR WALLBOARD  
PRESS TRANSMITTER  
TEST BUTTON  
TO SEND SIGNAL  
OR  
PLASTIC  
TWIST SMOKE  
SINGLE-GANG  
ELECTRICAL  
BOX  
ALARM CLOCKWISE  
TO LOCK TO MOUNTING  
PLATE  
 

Land Pride Lawn Mower ZRP44 User Manual
Legacy Car Audio Car Amplifier LA 1089 User Manual
LG Electronics Cell Phone BL20 User Manual
Life Fitness Home Gym FSFCM1 0102 001 User Manual
Lightolier Indoor Furnishings 1050SQIN User Manual
Magnavox VCR VRC602MG User Manual
Makita Impact Driver JN3201 User Manual
Meade Clock TE109NL M User Manual
Melissa Electric Shaver 638 149 User Manual
Microsoft Video Gaming Accessories 45X User Manual