Linear Satellite Radio 1051 User Manual

3. You should test your entire system occasionally in  
order to be sure that all components are working in  
good order.  
®
4. Linear Corporation’s dealers can provide you with  
information regarding the use of our radio controls,  
and can provide valuable installation and operation  
information, when requested.  
Model 1051  
SAFETY EDGE  
TRANSMITTER  
CAUTION: Any changes or modifications in intentional or unintentional radiators  
which are not expressly approved by LINEAR CORPORATION could void the  
user’s authority to operate this equipment. This applies to intentional and  
unintentional radiators certified per Part 15 of the F.C.C. rules and regulations.  
Important! Read  
Before Installation  
The MULTI-CODE 1051 transmitter has been  
designed to provide great reliability and safety, but it must  
be installed correctly. Read the enclosed instructions  
carefully.  
The Model 1051 may be used for a variety of purposes,  
and wherever remote signaling is desirable, as specified  
by FCC regulations. If this transmitter is to be used in an  
application which may be safety related be sure to take  
special precautions. Linear Corporation has taken every  
step to insure the best possible product, but you must be  
certain to install the 1051 transmitter correctly.  
Before installing the 1051 transmitter, open it up by  
removing the four screws which secure the top of the case.  
You will note that there is a terminal block (see figure 1), to  
which you will secure the wires coming from your device.  
Run your wire through the strain relief fitting, leaving  
enough wire to provide adequate length for stripping.  
YOUR WIRE SHOULD BE 18 TO 24 GAUGE, although any  
wire that fits snugly in the strain relief fitting may be used.  
Be sure to check the water-tightness of the fitting if you use  
anything other than 18-24 gauge wire, as this may  
compromise the integrity of the case. Put your two wires  
under the terminal blocks, and fasten by screwing down.  
Next, code your transmitter and, if necessary, your  
receiver. The code switch (see figure 1) allows for 1024  
possible combinations. If you have an existing receiver, you  
may code the 1051 to the same code, or you may choose to  
wire a separate receiver. If you wire a second receiver, be  
sure to separate the two receivers as much as possible, to  
avoid any possibility of interference.  
For service, return to your dealer or shop prepaid to:  
LINEAR CORPORATION  
2055 Corte del Nogal  
Carlsbad, CA 92009  
Copyright © 1999 Linear Corporation  
216977 A  
 

LaCie Computer Drive 4big Quadra User Manual
Lantronix Network Card 900 691 R User Manual
LG Electronics Clothes Dryer DLEY1701V User Manual
LG Electronics Flat Panel Television SAC30708043 User Manual
LG Electronics Telephone LDK User Manual
Makita Tool Storage HM0810 User Manual
Marmitek Door PK836 User Manual
Maytag Clothes Dryer MED5870TW0 User Manual
Meade Telescope 60AZ D User Manual
Metra Electronics Surge Protector 99 7308 User Manual