Linear Computer Keyboard DXS 10 EC User Manual

1. KEYPAD DETAIL  
2. TYPICAL WIRELESS KEYPAD PLACEMENT  
DXS-10/EC  
PRESS AND  
HOLD FOR  
2 SECONDS  
GREEN  
OPERATION  
LIGHT  
BY  
WIRELESS  
KEYPAD  
MODE BUTTONS  
FOR CHANGING  
MODES  
FIRE BUTTON  
TO SOUND  
SIREN AT ANY  
TIME  
FRONT  
ROOM  
For Use With DVS-2400/EC  
Security Console  
EMERGENCY  
BUTTON TO  
WINDOW  
TRANSMITTERS  
SOUND SIREN  
AT ANY TIME  
BEDROOM  
Installation  
Instructions  
MAIN  
CONSOLE  
FRONT  
DOOR  
WIRELESS  
KEYPAD  
PRESS THE STAR  
KEY TO RESET THE  
KEYPAD IF YOU ENTER  
THE WRONG CODE  
KITCHEN  
KEYPAD FOR  
ENTERING YOUR  
USER CODE  
KEY TO ACTIVATE  
HOME AUTOMATION  
OUTPUT (A)  
(760) 438-7000 • FAX (760) 438-7043  
3. OPENING KEYPAD  
4. TABLE-TOP USE  
5. WALL MOUNTING (INDOORS ONLY)  
FROM TOP OF CASE TWIST  
SCREWDRIVER BETWEEN  
CASE HALVES UNTIL IT  
POPS OPEN  
USE THE FOUR SCRATCH  
DETERRENT PADS PROVIDED  
FOR TABLE-TOP USE  
ATTACH REAR CASE TO WALL  
WITH THE TWO SCREWS PROVIDED  
CONNECT BATTERY  
TO BATTERY CLIP  
MOUNT AT A CONVENIENT  
LOCATION NEAR PRIMARY  
ENTRY/EXIT DOOR  
6. CLOSING KEYPAD  
7. PROGRAM KEYPAD INTO CONSOLE  
INTERNATIONAL WARRANTY  
This Linear product is warranted against defects in material and workmanship for twelve (12)  
months. The Warranty Expiration Date is labeled on the product. This warranty extends only to  
wholesale customers who buy direct from Linear or through Linear’s normal distribution  
channels. Linear does not warrant this product to consumers. Consumers should inquire from  
their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations or  
liabilities on the part of Linear Corporation for consequential damages arising out of or in  
connection with use or performance of this product or other indirect damages with respect  
to loss of property, revenue, or profit, or cost of removal, installation, or reinstallation. All  
implied warranties, including implied warranties for merchantability and implied  
warranties for fitness, are valid only until Warranty Expiration Date as labeled on the  
product. This Linear Corporation Warranty is in lieu of all other warranties express or  
implied. For warranty service on Linear equipment return product, at sender’s expense to:  
Linear Hong Kong 19/F Hounor Industrial Centre, 6 Sun Yip Street Chai Wan, Hong Kong  
Attention: Repairs Department  
2
SEND SIGNAL  
FROM KEYPAD  
START IN  
TEST MODE  
TEST  
THEN, SNAP CASE SHUT  
ENTER MASTER  
USER CODE  
PRESS  
TEST UNUSED SENSOR  
NUMBER  
ENTER AN  
REPAIRS POLICY  
Charges will be made for equipment that is not in warranty, shows customer abuse, or is damaged  
by the effects of lightning, water, fire, or other abnormal happenings.  
Customer’s equipment sent in for repair may be repaired or replaced with new or remanufactured  
equipment at Linear’s discretion.  
The customer is always responsible for shipping and handling charges to the repairsfacility. Linear  
will pay return shipping and handling charges on “in warranty” products shipped back to the  
customer. The customer will be billed for the return shipping and handling charges on “out of  
warranty” products.  
HOLD OFF BUTTON FOR  
3 SECONDS WHEN FINISHED  
TO EXIT LEARN MODE  
There will be a 50% expedite fee for any express requests.  
The International Sales Manager must be notified prior to the return of product to Linear. All  
international returns must have an International Repair Authorization number (IRA#). The number  
must be marked on all packages. Failure to do so will cause delays in processing.  
IMPORTANT !!!  
Linear radio controls provide a reliable communications link and fill an important need in portable  
wireless signaling. However, there are some limitations which must be observed. The radios are  
required to comply with local rules and regulations as radio devices. As such, they have limited  
transmitter power and therefore limited range.  
PRESS STAR KEY  
TO SEND SIGNAL  
R&TTE VAEE 27833, EMC, SFT, ETS  
A receiver cannot respond to more than one transmitted signal at a time and may be blocked by  
radio signals that occur on or near their operating frequencies, regardless of code settings.  
Changes or modifications to the device may void regulatory compliance. Infrequently used radio  
links should be tested regularly to protect against undetected interference or fault. A general  
knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or  
dealer, and these facts should be communicated to the ultimate users.  
Linear Corporation declares that the  
apparatus DXS-10/EC complies with the  
essential requirements and other relevant  
provisions of Directive 1995/5/EC  
1
FIRST HOOK BOTTOM  
EDGE TOGETHER  
Copyright © 2002 Linear Corporation  
220134 A  
 

KWC Plumbing Product 802 054 User Manual
Lenoxx Electronics Portable DVD Player PDV 702 User Manual
LG Electronics Cell Phone 265H User Manual
Linn Speaker Linn Melodik User Manual
Lucent Technologies Switch Multiservice Switch User Manual
Makita Saw 5037NB User Manual
Makita Work Light ML122 User Manual
Marmitek Stereo Receiver VideoControl3 User Manual
Mellerware Toaster 2 4 4 0 91 6 0 0 User Manual
Middleby Marshall Oven PS840 Series User Manual